15
2,3
5
1
2
1
Playing surround sounds
To play using a player with coaxial digital or analog
output jacks
1
Press POWER.
2
Press INPUT-2.
The currently set input mode (ANALOG or COAXIAL) is shown.
3
While the input mode is displayed, press INPUT-2 to change
the input mode.
Each time you press this button, the input mode alternates between
“ANALOG” and “COAXIAL”.
4
Start playing the software on the player.
5
Adjust the output level.
If you use one A/V amplifier...
Adjust the output level by using the amplifier’s master volume control.
If you use three power amplifiers...
Adjust the output level by using the ED-301’s VOLUME button.
To play using a DVD player with 5.1-channel output
jacks or an external decoder
1
Press POWER.
2
Press MULTI-CH INPUT.
The display will now show “MULTI-CH”.
Each time you press this button, the “INPUT-1” or “INPUT-2”
indicator shown at the upper right section of the display changes.
This button is used to change among the Audio, Video, and S-
Video output modes, not to change the input mode.
3
Start playing the software on the player.
4
Adjust the output level by using the master volume control of
the external decoder or A/V amplifier.
Note:
If your speakers are connected via three independent power amplifiers,
do not connect an external decoder or DVD player to the MULTI-
CHANNEL AUDIO INPUT jacks of the ED-301. Doing so may cause
damage to the power amplifiers or speakers because there is no means
of adjusting the output level.
DOLBY
DIGITAL
INPUT- 2
LS
RS
L
C
R
Input mode
INPUT-1
2
INPUT-1 or INPUT-2 indicator
