OMS LINEA ESSE S.T.01/3S ED.0 REV.14 03/2017
59
ASSEMBLY
Version with spittoon unit on the chair
1.
Remove the equipment from its packaging;
2.
Install the chair, secure the seat, insert the headrest and, where supplied, the right armrest.
3.
Lift the spittoon unit, fixing it to the chair with the supplied screws. As a precaution against accidental
damages, it may be better not to remove the packaging until the unit is fixed to the chair.
4.
Open the external spittoon unit guard and insert the instrument arm with small rotating movements.
5.
Proceed with the connections between the table and the spittoon unit. Pay close attention to insert
the "Panduit" connectors correctly and to the numbers of the wires to secure to the terminal box.
6.
Free the instrument group from all packaging and apply any accessories.
7.
Proceed connecting the transformer and dental unit to the floor box, complying with the numbering
of the wires to be connected to the terminal box of the transformer and inserting the "Panduit"
connector correctly.
8.
Finally, connect the rheostat to the transformer, inserting the blue connector directly onto the
transformer board, with the wires downwards.
9.
If the lamp is to be connected to the dental unit, the lamp stem must be fixed in the relative housing.
The two fixing screws are already in the spittoon unit.
WARNING
P
ay attention to the position of the water pipe so that it does not come into contact with the
armchair engine (if present)
Note:
Refer to the wiring and installation diagrams provided for all electrical connections.
Summary of Contents for LINEA ESSE
