Connection of RS-232C Interface (V720-CD1D)
Section 4-6
4-17
Assembly of Connector
1, 2, 3...
1.Process the end of the cable as shown below.
Conductors
Braided shield
Shield tape
Cable bushing
•
Insert the cable into the cable bushing.
•
Untangle the braided shield for approximately 10 mm and fold it back
on the cable bushing.
•
Apply shield tape to the untangled braided shield.
2.Solder the conductors to the plug pins.
Plug
Jumper
Cable bushing
Aluminum tape
Pin number
Symbol
Name
Shield
GR
Ground
5
SG
Signal ground
3
SD
Send data
2
RD
Receive data
7 (see note)
RS
Request to send
8 (see note)
CS
Clear to send
Note Short-circuit pins 7 (RS) and 8 (CS) with a jumper.
3.Attach housing A2 of the Hood to the Plug and secure the aluminum-
taped portion with the cable clamp and two screws.
Two, M26 lock screw
Housing A2
Cable clamp
Housing B2
4.Put on housing B2 to complete the connector assembly.
