![background image](http://html.mh-extra.com/html/omron/smartcontroller-ex/smartcontroller-ex_user-manual_1633417022.webp)
22
SmartController EX User's Guide
11069-000 Rev. H
3.2 Connecting Power
Position the card so its contacts are facing towards the controller and to the left. The
label will be facing to the right.
4. Insert the SD card into the controller.
Once installed, we recommend that you do not repeatedly remove and insert the SD card.
3.2 Connecting Power
The SmartController EX motion controller requires filtered 24 VDC power.
NOTE:
Users must provide their own power supply.
Make sure the power cables
and power supply conform to the specifications that follow.
24 VDC Power Specifications
Table 3-3. Specifications for 24 VDC User-Supplied Power Supply
User-Supplied Power Supply
24 VDC (-10%, +5%), 120 W (5 A)
Circuit Protection
Not more than 8 A (below the amper-
age rating of the cable used)
Power Cabling
1.5 - 1.85 mm
2
(16-14 AWG), full-
cover, braided shield cable, maximum
length 10 meters
Shield Termination
Braided shield connected to the marked
frame ground screw on the right side of
the controller (near the XDC con-
nector). On the other end of the cable,
the shield should be connected to the
power supply chassis.
1
2
6
5
4
3
Figure 3-6. User-Supplied 24 VDC Cable