![background image](http://html1.mh-extra.com/html/omron/prt1-com/prt1-com_operation-manual_744566107.webp)
6-3
Section
Transistor Output Units
96
Connector Cables
When a Transistor Output Unit (high-density connector) is to be connected to an
OMRON I/O Block or a Connector--Terminal Block Conversion Unit, use the
cables (sold separately) listed in the following table.
Manufacturer
Model number
Corresponding device
OMRON
XW2Z-
jjj
B
Connector--Terminal Block Conversion Unit
XW2B-40G4
XW2B-40G5
G79-O
j
C-
j
I/O Block
G7TC-OC16-1
G70D-SOC16-1
G70D-FOM16-1
G70A-ZOC16-4
M7F
Note
V terminals and G terminals are internally connected. When the I/O power is
being supplied, the power can be supplied to the output devices from the V and
G connectors. Current supplied in this way, however, must be less than 2 A. If,
instead of using the V and G connectors, the power supply is wired to the
terminal block as shown in the following diagram, the current supplied must be
less than 4 A.
Output Unit
I/O Block
Load
Dimensions
(Unit: mm)
Approx. 70
Note
The vertical center of the Unit is 4.9 mm lower than the center of the DIN track.
The Unit therefore extends downward 41.4 mm (including the mounting hook)
from the DIN track center.