Page 1 of 9
© 2021 CommScope, Inc. All Rights Reserved
Contents
Installation Instructions
660105574
Rev. A
TC-1511-IP
Rev. A, September 2021
www.commscope.com
BUDI-R
1
General product information
The BUDI-R is a wall-mount terminal used to deploy and manage fiber optic networks in a small to mid-sized multiple
dwelling unit (MDU) or multiple tenant unit (MTU). Installation can be completed by one person. The BUDI-R contains an
internal fiber spool loaded with 24 SC adapters and 2 12-fiber Indoor/Outdoor cable terminated with an MPO connector
or an HMFOC connector. Certain product configurations will come with an external spool holding an extension of the cable
beyond what the internal spool can hold.
Within the BUDI-R, the cable is pre-terminated to two rows of SC adapters used to connect patch cord drops to subscribers.
The BUDI-R has an inner cover and is only removed for connector cleaning when desired.
2
General safety precautions
2.1
Fiber optic cables may be damaged if bent or curved to a radius that is less than the recommended minimum
bend radius. Always observe the recommended bend radius limit when installing fiber optic cables and patch cords.
2.2
Infrared radiation is invisible and can seriously damage the retina of the eye. Do not look into the ends of any
optical fiber. Do not look directly into the optical adapters of the adapter packs. Do not assume the laser power is turned off
or that the fiber is disconnected at the other end.
A protective cap or hood MUST be immediately placed over any radiating adapter or optical fiber connector to avoid the
potential of dangerous amounts of radiation exposure. This practice also prevents dirt particles from entering the connector
and adapter.
1 General product information ������������������������������������������������������ 1
2 General safety precautions ���������������������������������������������������������� 1
3 Determining where to mount the BUDI-R �������������������������������� 2
4 Unpacking the external spool (if applicable) ���������������������������� 2
5 Paying out the cable on external spool (if applicable) ������������ 2
5.1 Preparing the MPO cable ............................................................................... 2
5.2 Preparing HMFOC cable ................................................................................. 3
5.3 Pulling the cable ...................................................................................................3
6 Remove packaging �������������������������������������������������������������������������4
7 Mounting the BUDI-R ��������������������������������������������������������������������5
8 Paying out the cable on the internal spool ���������������������������������6
9 Installing patch cords���������������������������������������������������������������������7
10 Trademarks and patents ���������������������������������������������������������������9
11 Contact information ����������������������������������������������������������������������9
Mounting ears
Securing eye
Lock
Internal fiber
spool
2 MPO or 2 HMFOC
Inner cover
Patch panel
24 SC
