4-3-2
Panel Mount Procedure
Ensure the panel cut out is ready before beginning the mounting procedure.
Refer to
Tools required: Panel Mounting Brackets and a Philips screwdriver.
Optional hardware: High-Pressure Waterproof Attachment (PWA)
Panel Mounting Bracket
Philips screwdriver
High-Pressure Waterproof Attach-
ment (PWA)
The housing of the Industrial Panel PC is equipped with recesses for the Panel Mounting Brackets.
These brackets are used to fasten and secure the Panel PC to the mounting surface.
Use the following procedure to mount the Panel PC to the mounting surface:
1
Insert the Industrial Panel PC from the front side of the panel.
Vertical
Horizontal
2
Insert the Panel PC into the mounting surface cut out so the bezel
B
touches the mounting
surface.
3
Mount the optional High-pressure Waterproof Attachment (PWA) to greatly reduce the risk of
water entry. Water entry may cause severe equipment damage.
Slide the PWA over the Panel PC from the back until the flat side of the PWA is flat against the
inside of the panel, as shown in the following figure.
4 Installation
4-5
NY-series NYE Industrial Panel PC Conversion Guideline for NS-series products (P157)
4-3 Mount
4
4-3-2
Panel Mount Procedure
