Temperature Controller CompoWay/F Driver
GP-Pro EX Device/PLC Connection Manual
43
6.3
In-Panel NEO
This address can be specified as system data area.
Command code list
Device
Bit Address
Word Address
32bit
Remarks
Variable
Areas
*1
*1
Available variable area range varies depending on the using Temperature Controller. Refer to the manual of
OMRON Temperature Controller for setting.
C00000.00-C00006.31
C00100.00-C00106.31
C00000-C00006
C00100-C00106
Double Word Device
*2*3
*2
When you write the bit address, the Display reads the word address corresponding to that of the External Device
first. Then, it changes the target bit address among the word data once read and returns the word data to the
External Device. Note that the correct data may not be written if you change the word address value in the ladder
program while the Display reads the data of the External Device and returns it to the External Device.
*3
Write disable
C10000.00-C10019.31
C10100.00-C10119.31
C10000-C10019
C10100-C10119
Double Word Device
C30000.00-C3003E.31
C30100.00-C3013E.31
C30000-C3003E
C30100-C3013E
Double Word Device
*4
*4
When writing, switch the setting area of the Temperature Controller to setting area 1.
C50000.00-C50000.31
C50100.00-C50100.31
C50000
C50100
Double Word Device
C70000.00-C70001.31
C70100.00-C70101.31
C70000-C70001
C70100-C70101
Double Word Device
Operation
command
*6
-
A0000-A000C
Word Device
*5
*5
Read disable
*6
When executing the operation command (write), specify the directive code for the device address. Set the
related information for the writing value. Set the related information in hexadecimal number, such as 0x00,
0x01. Set the device code to be used in the painting software as A, and enter each command code instead of the
device address.
Command
code
Related information
* 2
Command comment
Device address
00
“00” or “10”:OFF(disabled)
“01” or “11”:ON(enabled)
Communication writing
A0000
01
“00”: Run CH1
“01”: StopCH1
“10”: Run CH2
“11”: Stop CH2
“F0”: Run CH1, CH2
*1
“F1”: Stop CH1, CH2
Run/Stop
A0001
02
“00”: Select target value 0 for CH1
“01”: Select target value 1 for CH1
“10”: Select target value 0 for CH2
“11”: Select target value 1 for CH2
“F0”: Select target value 0 for CH1, CH2
“F1”: Select target value 1 for CH1, CH2
Multi-SP
A0002
continued to next page