Omron In-Panel NEO Series, Connection Manual, Page: 42 / 48

Temperature Controller CompoWay/F Driver
GP-Pro EX Device/PLC Connection Manual
42
A soft reset will not respond. (No service PDU response)
When all channels are specified, only enabled channels will respond and processing will begin from Channel 1.
If an error is detected on any channel, "Operation error" will be defined. When all channels end normally, normal
end will be defined.
01
0 to 3, F
*2
0: Run
1: Stop
Run/Stop A0001
02
0 to 3, F
*2
0 to 7: Bank 0 to 7 Bank switch A0002
03
0 to 3, F
*2
0: Currently selected PIDset
No.
1 to 8: PIDset No.
AT execute A0003
04 0
*1
0: Backup mode
1: RAM write mode
Write mode A0004
05 0
*1
0 Save RAM data A0005
06 0
*1
0 Soft reset A0006
07 0
*1
0 Setting area 1 transfer A0007
08 0
*1
0 Protect level transfer A0008
09
0 to 3, F
*2
0: Auto mode
1: Manual mode
Auto/Manual A0009
0A
0 to 3, F
*2
0: Cancel AT cancel A000A
0B 0
*1
0 Initialize settings A000B
0C
0 to 3, F
*2
0 Cancel latch A000C
0D
0 to 3, F
*2
0: LSP
1: RSP
SP mode A000D
*1 Operates for all channels.
*2 Specify for every channel. (0: CH1, 1:CH2, 2:CH3, 3:CH4, F:All channels)
• To enable " Use System Area " in the system area setting of GP-Pro EX may cause a
malfunction. Do not set " Use System Area " .
• You can set only Read Area Size for the system area available to use in the Temperature Controller.
Please refer to the GP-Pro EX Reference Manual for Read Area Size.
Cf. GP-Pro EX Reference Manual "LS Area (Direct Access Method Area)"
• Please refer to the precautions on manual notation for icons in the table.
)
"Manual Symbols and Terminology"
• Even if you use the nonexistent address, read error may not be displayed. In this case, "0" is
retained for the read data. Note that the writing error is displayed.
Command
code
Related information
Command comment Device address Higher
byte
Lower byte