Omron In-Panel NEO Series, Connection Manual, Page: 44 / 48

Temperature Controller CompoWay/F Driver
GP-Pro EX Device/PLC Connection Manual
44
03
“00”: Cancel CH1 AT
“01”: Execute CH1 AT
“10”: Cancel CH2 AT
“11”: Execute CH2 AT
“F0”: Cancel CH1, CH2 AT
*1
“F1”: ExeculteCH1, CH2 AT
*1
ATexecute/cancel A0003
04
“00” or “10”: Backup
“01” or “11”: RAM
Write mode A0004
05 “00” or “10” Save RAM data A0005
06 “00” or “10” Soft reset A0006
07 “00” or “10” Setting area 1 transfer A0007
08 “00” or “10” Protect level transfer A0008
09
“00”: Auto for CH1
“01”: Manual for CH1
“10”: Auto for CH2
“11”: Manual for CH2
“F0”: Auto for CH1, CH2
*1
“F1”: Manual for CH1, CH2
*1
Auto/Manual A0009
0A “00” or “10” PV hold A000A
0B “00” or “10” Initialize settings A000B
0C
“00”: Cancel alarm latch for CH1
*1
“01”: Cancel alarm latch 2 for CH1
*1
“02”: Cancel alarm latch 3 for CH1
*1
“0F”: Cancel all alarm latches for CH1
*1
“10”: Cancel alarm latch for CH2
*1
“11”: Cancel alarm latch 2 for CH2
*1
“12”: Cancel alarm latch 3 for CH2
*1
“1F”: Cancel all alarm latches for CH2
*1
“F0”: Cancel alarm latch for CH1, CH2
*1
“F1”: Cancel alarm latch 2 for CH1, CH2
*1
“F2”: Cancel alarm latch 3 for CH1, CH2
*1
“FF”: Cancel all alarm latches for CH2
*1
Cancel alarm latch A000C
*1 Upgraded pulse output models and analog output models can support these commands.
*2 Command codes for which the related information is indicated as "
“00” or “10”" or "“01” or “11”" use the
same command for both CH1 and CH2. You can use either value in the related information. (The result will be the
same.)
• To enable " Use System Area " in the system area setting of GP-Pro EX may cause a
malfunction. Do not set " Use System Area " .
• You can set only Read Area Size for the system area available to use in the Temperature Controller.
Please refer to the GP-Pro EX Reference Manual for Read Area Size.
Cf. GP-Pro EX Reference Manual "LS Area (Direct Access Method Area)"
• Please refer to the precautions on manual notation for icons in the table.
)
"Manual Symbols and Terminology"
• Even if you use the nonexistent address, read error may not be displayed. In this case, "0" is
retained for the read data. Note that the writing error is displayed.
Command
code
Related information
* 2
Command comment Device address