Omron i4-350L, User Manual

Page: 77 / 174

3-2 Mounting the Robot
Use the information in the following sections to mount the robot.
3-2-1
Robot Mounting Surface
The following considerations must be made when preparing a robot mounting surface.
• It must be smooth and flat.
• It must be rigid enough to prevent vibration and flexing that is caused by reactionary forces during
fast robot motion.
• It must be designed to support the weight of the robot with payload.
• Table-mounted robots must be placed on a level, horizontal surface.
• Wall-mounted robots must be fastened to a 90° vertical surface.
• When the robot is mounted to a vertical surface, considerations for preventing a collision with the
mounting surface should be made.
WARNING
If a robot is mounted to a surface with inadequate stiffness, damage to the z-axis quill
or other mechanical components can result from excessive oscillation during opera-
tion.
Precautions for Correct Use
• It is recommended to use a properly secured, 18 mm (minimum) thick steel plate with a maxi-
mum surface roughness of 25 μm as a robot mounting surface.
• Keep a minimum of 300 mm clearance from the Primary Interface Panel to allow for switch
and cable connection access.
3-2-2
Mounting Procedure
Use the following procedure to mount the robot.
WARNING
• Always use proper lifting technique when lifting the robot. Failure to comply could
result in the robot falling and causing either personnel injury or equipment damage.
• The robot's center of mass can cause the robot to fall over if the robot is not proper-
ly secured with the mounting bolts.
Precautions for Safe Use
The robot can be lifted by hand. Only use the base and inner link when lifting the robot. Never
maneuver the robot using the quill or flyover assemblies.
Precautions for Correct Use
The mounting surface should be clean and prepared according to the information provided in
3-2-1 Robot Mounting Surface on page 3-5 before attempting to mount the robot.
3 Installation
3-5
i4L Robots with EtherCAT User's Manual (I659)
3-2 Mounting the Robot
3
3-2-1
Robot Mounting Surface