![background image](http://html1.mh-extra.com/html/omron/f250/f250_setup-manual_741266015.webp)
11
F250
Setup Manual
INT
R
ODUC
TI
ON
Pr
ecau
tion
s in
u
sing
th
e
Pro
d
u
ct
INTRODUCTION
Component Installation and Handling
OMRON Components
Use a Camera, Camera Cable, and Console designed specifically for the Controller.
Connecting Cables
Always turn OFF the Controller's power before connecting or disconnecting a camera or cable.
Handling the Camera
The Camera's case is connected to the 0V line in the internal circuits. Observe the following
precautions to prevent noise interference.
•
Do not ground the Camera.
•
Do not remove the base attached to the Camera.
•
Do not remove the ferrite core attached to the F150-VS Camera Cable.
Optical axis of a special camera
The center of the optical axis varies with the camera used. Therefore, when installing the
camera, always check the center of the image displayed on the monitor.
Touching Signal Lines
To prevent damage from static electricity, use a wrist strap or another device for preventing
electrostatic discharges when touching terminals or signal lines in connectors.
Handling the Memory Card
•
To prevent damage from static electricity, do not touch the Memory Card directly while it is installed in the
Controller.
•
To remove a Memory Card, turn OFF the power supply to the Card (using the menu command) or turn OFF
the Controller. Press the eject button to eject the Card.The Memory Card or the Controller itself may be
damaged if a Memory Card is removed while power is being supplied. (The power supply is stopped using
the menu)