1-6
Section
4. Initial Settings
•
Set the Communications Switches on the front of the CPU Unit, if neces-
sary. (The switches must be set when a device other than the Program-
ming Console is connected or the standard communications settings are
not used.)
•
Connect the Programming Console, set the mode switch to PROGRAM
mode, and turn ON the PC.
•
Check the CPU Unit’s LED indicators and the Programming Console’s dis-
play.
•
Clear the PC’s memory. (All Clear)
•
Make PC Setup settings.
Refer to
3-3 Installing the CPM2C
and
4-3-4 Preparation for Operation
for
details.
5. Create Ladder Program
•
Create a ladder program to control the system.
Refer to
Section 4 Using Programming Devices
and the
Programming
Manual
for details.
6. Write Ladder Program in PC
•
Write the ladder program in the PC with the Programming Console or
transfer the program to the PC from the Support Software.
Refer to
Section 4 Using Programming Devices,
to the
SYSMAC Support
Software Operation Manuals
and to the
CPT User Manual
for details.
7. Test Run
•
Check I/O wiring in PROGRAM mode.
•
Check and debug program execution in MONITOR mode.
Refer to
Section 5 Test Runs and Error Processing
for details.
Summary of Contents for CPM2C
