LVS-RIMS Quality Control Process Operations Manual Version 5.6.X
LVS-RIMS Quality Control Process Operations Manual Version 5.6.X
Page 25 of 35
QC.INI FILE
The QC.ini file tells the QC software where to find the LVS-7000 log files and where to save the log files when
they have been reviewed or Quality Controlled.
[QC]
In1=\\Server1\PathToJobsDir
In2=
In3=
Out=\Jobs
Turret=
TurretDelayInches=0
S
ETTING
D
EFINITION
In1=
Tells the QC computer where to find the LVS-7000 Job files; it usually
points to the computer and directory where the LVS-7000 saves its Jobs.
For example, if the LVS-7000 computer’s IP Address is 192.168.0.101
and the
Omron Microscan
folder was shared, then In1 could be listed as:
In1=\\192.168.0.101\Microscan\LVS 7000\Jobs
In2=
Used if there is more than one LVS-7000 system.
In3=
Used if there is more than two LVS-7000 systems.
Out=
This is where the QC program saves the Log files that were edited. The
“./Jobs” path indicates that the QC’s Job folder would be in the same
location as the QC program. In this case, the Out path could also be
listed as:
Out= C:\Users\<username>\AppData\Roaming\Microscan\LVS QC\Jobs
Turret=
This setting enables QC to operate in Turret cut roll mode.
TurretDelayInches=0
This setting is the delay in inches from the time the turret cut signal is
sent, to the actual physical location of the cutter. This setting should
match the setting in the LVS7000.ini file.