LVS-RIMS Quality Control Process Operations Manual Version 5.6.X
LVS-RIMS Quality Control Process Operations Manual Version 5.6.X
Page 23 of 35
9. Follow the above steps until either the green dot has reached the viewing area or the job has physically
been completed.
10. Upon completion of a job, perform the following steps in the exact order as listed below.
a) Press the “End Roll” button on the LVS-RIMS software.
b) Remove all remaining labels from the completed job.
c) Load the roll for the new job and bring the LVS bar code to the home position, which is the point
where defects are located when the corresponding dot on the screen is at the blue arrow on the
screen.
d) Press the “Enter Barcode” button and continue from Step 6 above.
Note:
If the operator does not press the “End roll” button before clearing the old job and
entering the new job, the operator
MUST
wait a minimum of 10 seconds after pressing the “End
Roll” button before pressing the “Enter Barcode” button.
The next defect
will appear in the
thumbnail
window.
