80-J4866-2 Rev. G
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
12-19
System Verification
Basic MCP100 System Verification Procedure
11.
Tap the
Outbox
tab to display the message
that was just sent. Orange arrows indicate the
message is in transit; a green “
” (check
mark) indicates the message has been
acknowledged.
• If the message is acknowledged, go to
• If the message is not acknowledged,
perform the diagnostic procedure in
Chapter 7 in the
MCP100 Diagnostic
Guide.
12.
Have the dispatcher send a test message to
the MCP100. If the dispatcher is not available,
call Omnitracs Customer Support
(800-541-7490) to have the message sent.
If the Remote Message Waiting Light or
Message Waiting Buzzer feature is installed,
you can also test them at this time by having
an Important or Sleepy Important message
sent.
13.
After a few minutes, the unit should chirp, the
Message Waiting Light should come on, and a
voice notification will tell you the message has
been received. Tap the
Inbox
tab to display
the dispatcher’s message.
• If the MCP100 received the message, go to
• If the MCP100 did not receive the
message, perform the diagnostic
procedure in Chapter 7 in the
MCP100
Diagnostic Guide.
Contact the Dispatch
Center and have the
dispatcher send a test
message to the MCP
Dispatch
Center
Terrestrial
Antenna
OM/E-0128-050TQMCP
