Omni8/16C/Omni8P User Manual
UMC1480R24.pdf
26
© Omniflex 2021
Markings on the LED board indicate the correct insertion orientation. If an LED board is inserted the wrong
way around, it will not work, but no damage will be done.
1. Insert the retaining clip
2.
Press the LED board gently
over the pins
3.
Press the LED Board on to the
retaining clip
3.10
Removing Back-lit LED boards
Caution: It is recommended that power to the unit be SWITCHED OFF before insertion/removal of LED
boards to prevent damage.
To remove Back-lit LED Boards, follow this procedure:
1.
Snap out the relevant clear plastic window.
2.
Grip the LED board on its edges. An ideal tool to do this is an IC extractor (see the pictures).
3.
Remove any lamps that may already be installed. (Backlit LED boards can be installed in units that
have incandescent lamp holders installed, but only after the bulbs have been removed.)
4.
Be careful NOT to pull on the black connector, as tempting as it seems. You will break the connector
and not remove the LED board.
Markings on the LED board indicate the correct insertion orientation. If an LED board is inserted the wrong
way around, it will not work, but no damage will be done.
1. Grab the LED board by its edges
while squeezing the barb on the
retaining clip
2.
Pull the board out by its
edges
3.
Do NOT attempt to pull the
LED board out by its central
connector.
