Omni8/16C/Omni8P User Manual
UMC1480R24.pdf
25
© Omniflex 2021
3.8
Installing the Internal Pushbutton Station
The control pushbuttons required to manage the alarm sequences selected in the Omni8/16C may be
located internal or external to the Omni8/16C.
If mounted externally, then they must be wired to the terminals on the rear of the unit. See Section 4.12 for
further details.
The control pushbuttons may be mounted internal to the Omni8/16C using the optional Integral
Pushbutton Station (Model Number C1420).
This Internal Pushbutton Station is installed in window position 8 in the Omni8C and In window position 16
in the Omni16C (the right hand bottom corner in each case.)
This window position is then no longer available as a display point (although the internal logic remains fully
operational).
To install the Internal Pushbutton Station, follow this procedure:
1.
Snap out the right hand bottom window.
2.
Plug in the Integral Pushbutton Station into the connector visible through the window.
3.
Snap the Integral Pushbutton Station into position.
Plugging in PBS
After plugging in
Complete
3.9
Installing Back-lit LED boards
Caution: It is recommended that power to the unit be SWITCHED OFF before insertion/removal of LED
boards to prevent damage.
To install Back-lit LED Boards, follow this procedure:
1.
Snap out the relevant clear plastic window.
2.
Remove any lamps that may already be installed. (Backlit LED boards can be installed in units that
have incandescent lamp holders installed, but only after the bulbs have been removed.)
3.
Using a pair of long-nose pliers, grip the backlit LED board by the central connector, and carefully insert
on to the gold pins located in the centre of the window.
4.
Press the board firmly into position so that the white locating spacer clips into the locating hole in the
back of the window.
