Figure B-6 Sensor Cables Connection
7. After all the steps above are completed, the connected sensor should look like this:
Figure B-7 Sensor connected to Datalog X-PRO.
Figure B-8 Interface Pin-Out.
In the scheme:
●
VCC_S:
should be connected to sensor’s VCC. 3.3V.
●
GND_S:
should be connected to sensor’s GND.
●
SDA:
It must be connected to the SDA channel of a digital sensor; for example, of type I2C.
This pin could be configured, as well, as an I/O port in the firmware.
●
SCL:
It must be connected to the SCL channel of a digital sensor; for example, of type I2C.
This pin could be configured, as well, as an I/O port in the firmware.
www.omicroning.co March 2020
46
