57
Appendix F AScII / TeLNeT commANdS TABLe
(continued)
* An example of the status of a Connector/Transmitter
Command:
EQNG00A
Response:
7
EngrLAB 01000000 2.0
7
is the Device ID (DID) of the Connector/Transmitter.
EngrLAB
is the name for the Connector/Transmitter.
“01000010”
is the bitmap representation of the internal state. The meaning for each bit
is described below (bit 7 starts from the left).
Bit 7
shows if the sensor is plugged into the Connector/Transmitter. ‘1’ means there is
no sensing device detected.
Bit 6
shows if the communication to the Connector/Transmitter is lost. ‘1’ means there
has not been any data received from that particular Connector/Transmitter for 1 minute
or 4 times the update rate, whichever is a longer time interval.
Based on the above information, Connector/Transmitter # 7 has not been communicating
with the Receiver.
Reading/parameter for ERDR commands
Options
Reading/parameter
(lower case)
a
Sequence number
b
Device type
c
First reading
d
Second reading
e
Third reading
i
Update rate
j
Battery voltage
k
Signal strength
l
Success rate
q
Name
r
Status
Connector/Transmitter Types
UWTC B Type TC
221
UWTC K Type TC
230
UWTC C Type TC
222
UWTC N Type TC
233
UWTC E Type TC
224
UWRTD
235
UWRH
227
UWTC R Type TC
237
UWIR
228
UWTC S Type TC
238
UWTC J Type TC
229
UWTC T Type TC
2
