2.3 DIP Switch Setup - Receiver
2.3.1 Wireless Settings
Figure 2.3 8 Position DIP Switch Setup
Once the End Devices and the Receiver start communicating, make sure to push DIP
switch
#1,
located on the back of the Receiver to the
ON
position.
2.3.2 Ethernet Settings
Figure 2.4 Ethernet - 4 Position DIP Switch Setup
To set the Receiver to factory default settings:
1) Slide DIP switch
#2
to
ON
position.
2) Power the Receiver on and wait about 10 seconds until the Receiver fully
boots up.
3) Set the DIP switch
#2
back to
OFF
position (it does not matter if the Receiver
is powered ON or OFF, just make sure that the DIP switch is set to OFF,
otherwise, every time the unit is power-cycled the factory settings will take
over).
Coordinator
Rear View
OFF
ON
1
4
(Shown in
"OFF" Position)
OFF
ON
1
8
(Shown in
"OFF" Position)
6
1) N/C
2) To change Ethernet settings
to factory default
3) To enable/disable DHCP
4) N/C
Rear View
1)
To change Wireless
settings to factory default
2-8) N/C
Rear View
