29
Toggles with the temperature value that should be input to
perform the low calibration operation.
The low calibration operation is triggered by pressing the
up arrow key.
Toggles with the temperature value that should be input to
perform the high calibration operation.
The high calibration operation is triggered by pressing the
up arrow key.
Calibration Menu
Options Menu
Display Parameter
Selection
Installed Card
Serial Communications
Serial Communications
with Switch Input
Remote Analog Setpoint
Auxiliary Output
Alarm
Switch Input with Alarm
Supervisor Menu
Display Parameter
Selection
Output 1
0 to 100%
Failsafe State
of output
Output 2
0 to 100%
Failsafe State
of output
Loop Break Time
Off, 4-9600 sec
Highest Reading
n/a
Lowest Reading
n/a
Load Default
Parameters
Choosing “Yes” to Load Default Parameters resets all menu
parameters to factory settings.
The Failsafe State is
only enforced when a
problem is detected
with the process input.
It is not reliably
enforceable in
instances of internal
circuitry failure such as
EEPROM problems.
Output % High Limits
are ignored when the
unit enters a Failsafe
State.
28
NOTE:
The following seven parameters are only available when
multi-step ramp is selected.
Display Parameter
Selection
Recycle Number
0-99,
(Recipe Executions)
Power Fail Resume
Off
On
Ramp Times 1-8
0-9999 mins.
Ramp Events 1-8
Alarm 1 On
Alarm 1 Off
Alarm 2 On
Alarm 2 Off
Disabled
Soak Levels 1-8
Display Units, FS
Soak Times 1-8
0-9999 mins.
Soak Events 1-8
Alarm 1 On
Alarm 1 Off
Alarm 2 On
Alarm 2 Off
Disabled
Recipe (Ramp/
Soak) Menu
For Ramp Events and
Soak Events to be
employed, Alarm 1 or
Alarm 2 must be set for
event usage
in
the Alarm Menu.
