![background image](http://html1.mh-extra.com/html/omega/cn8200-series/cn8200-series_user-manual_737605013.webp)
17
Input
Used to select sensor-related parameters, such as input type,
limits, and scaling.
Display
Used to set or change decimal position and display units.
Output
Used to specify output usage, control methods, and alarms.
Control
Used to select parameters associated with the control methods.
Alarm
Used to select alarm parameters .
Note: This menu is also functional for controllers not
equipped
with alarm hardware; however, alarm indication
will be only visual via the A1 and A2 LEDs on the front panel.
Tune
Used to set the autotune damping parameter.
Recipe
Used to set ramp and soak parameters.
Supervisor
Used to set fail-safe and supervisory parameters.
Calibration
Used to recalibrate input.
Option
Used to select installed option.
Communications
(Option) Used to set serial communications parameters.
Contact/Digital
Input
(Option) Used to select switch input functions.
Remote Analog
Setpoint
(Option) Used to enter remote analog setpoint parameters.
Auxiliary Output
(Option) Used to set auxiliary output parameters.
Menus and Parameter
Descriptions
Menus and Parameters
16
Initial Setup
Sequence
4) If manual tuning the controller, set Control Menu
parameters
by pressing the Menu Access
key
repeatedly until
is displayed. Then, use the
Mode/Enter
key to index through the available
selections and the Raise
or Lower
keys to select
the appropriate setting. Otherwise, proceed to Step 6.
5) If autotuning the controller,
press and hold the Menu
Access
key for three seconds to access the menu
system. Press the Menu Access key repeatedly until the
Autotune Damping parameter
is displayed. Make
sure the Damping parameter is set properly (see page 37).
Press and hold the Menu Access
key for three
seconds to return to the Process Variable display and
proceed to Step 4 on page 43.
6) Return to Process Variable Display.
Press and hold
the Menu Access
key for three seconds to return
to PV display.
7) Adjust setpoint.
Use the Raise
or Lower
key to
enter the desired setpoint. Wait for process to stabilize
before proceeding, e.g., in the case of a heating process,
return to ambient temperature.
8
) Security Level.
Press and hold the Menu Access key
for approximately 10 seconds until
is displayed.
Using the Raise or Lower keys, set the most restrictive
level suited to your application. See page 16.
IMPORTANT: Upon
entering a new value,
you MUST either press
the Mode/Enter key, the
Menu Access key, or
index to a different
parameter in order for
the new value to register.
The controller will NOT
accept new values
without a key press.