PLATINUM
TM
Series User’s Guide
34
Reference Section: Initialization Mode (INIt)
Confirm the
SAVE
command. This saves the configuration to the file number specified. If the
SAVE
operation fails, the failure code
w004
is displayed. If the
SAVE
operation is successful,
doNE
is displayed.
4.8
Load a Configuration for All Parameters from a File (INIt > LoAd)
Select the Load a Configuration (
LoAd
) command. If no thumb drive is present the failure code
E010
is displayed. Otherwise, a numeric designation for the file to be loaded is then specified
and confirmed before the
LoAd
command executes.
Select a numeric file name from the range 0–99.
Confirm the
LoAd
command. This loads the configuration from the file number specified. If
the
LoAd
operation fails, the failure code
w003
is displayed. If the
LoAd
operation is
successful,
doNE
is displayed.
4.9
Display Firmware Revision Number (INIt > VER.N)
Select the Display Firmware Revision Number (
VER.N
) function. The currently installed version
number is displayed in the format 1.23.4 where “1” is the major revision number, “23” is the
minor revision number, and “4” is the bug fix update number.
4.10
Update Firmware Revision (INIt > VER.U)
Select the Update Firmware Revision (
VER.U
) function. Note that updating your firmware will
reset the unit to factory defaults as well. If you want to keep you configuration settings, save
them before installing new firmware.
The LED display shows
ok?
and requires confirmation. Confirm the firmware update. New
firmware will then be read from a thumb drive connected to the USB port.
4.11
Reset to Factory Default Parameters (INIt > F.dFt)
Select the Reset to Factory Default Parameters (
F.dFt
) function. The LED display shows
ok?
and requires confirmation.
Confirm the parameter reset.
4.12
Password-Protect Initialization Mode Access (INIt > I.Pwd)
Select the Password Protect Initialization Mode Access (
I.Pwd
) function.
Navigate to the desired setting. Settings include the following:
•
No
– Do not require a password for
INIt
Mode (factory default)
•
yES
– Require a password for
INIt
Mode; users will be prompted for this password
when selecting
INIt
Select the indicated setting.
If
yES
, set the numeric password from the range 0000–9999.
Confirm the password.
4.13
Password-Protect Programming Mode Access (INIt > P.Pwd)
Select the Password Protect Programming Mode Access (
P.Pwd
) function.
Omega Engineering | www.omega.com
