Omega CN16Pt, User Manual

Page: 20 / 61

PLATINUM
TM
Series User’s Guide
20 Complete Menu Structure
Level
2
Level
3
Level
4
Level
5
Level
6
Notes
oN.oF ACtN RVRS Off when > SP1 , on when < SP1
dRCt Off when < SP1 , on when > SP1
dEAd ____ Deadband value, default = 5
S.PNt SP1 Either Setpoint can be used of on/off, default is SP1
SP2 Specifying SP2 allows two outputs to be set for heat/cool
ALM.1 Output is an Alarm using ALM.1 configuration
ALM.2 Output is an Alarm using ALM.2 configuration
RtRN Rd1 ____ Process value for oUt1
oUt1 ____ Output value for
Rd1
Rd2 ____ Process value for oUt2
oUt2 ____ Output value for Rd2
RE.oN Activate during Ramp events
SE.oN Activate during Soak events
CyCL ____ PWM pulse width in seconds
RNGE 0–10 Analog Output Range: 0–10 Volts
0–5 0–5 Volts
0–20 0–20 mA
4–20 4–20 mA
0–24 0–24 mA
oUt2 oUt2 is replaced by output type
oUt3 oUt3 is replaced by output type
PId.S ACtN RVRS Increase to
SP1
(i.e., heating)
dRCt Decrease to SP1 (i.e., cooling)
A.to ____ Set timeout time for autotune
AUto StRt Initiates autotune after StRt confirmation
GAIN _P_ ____ Manual Proportional Band setting
_I_ ____ Manual Integral Factor setting
_d_ ____ Manual Derivative Factor setting
%Lo ____ Low clamping limit for Pulse, Analog Outputs
%HI ____ High clamping limit for Pulse, Analog Outputs
AdPt ENbL Enable fuzzy logic adaptive tuning
dSbL Disable fuzzy logic adaptive tuning
RM.SP oFF Use
SP1
, not remote Setpoint
oN 4–20 Remote analog Input sets
SP1
; range: 4–20 mA
Note: This submenu is the same for all RM.SP ranges.
RS.Lo ____ Min Setpoint for scaled range
IN.Lo ____ Input value for RS.Lo
RS.HI ____ Max Setpoint for scaled range
Omega Engineering | www.omega.com