Omega CN16Pt, User Manual

Page: 18 / 61

PLATINUM
TM
Series User’s Guide
18 Complete Menu Structure
Level
2
Level
3
Level
4
Level
5
Level
6
Level
7
Level
8
Notes
4800 4,800 Bd
2400 2,400 Bd
1200 1,200 Bd
57.6 57,600 Bd
115.2 115,200 Bd
PRty odd Odd parity check used
EVEN Even parity check used
NoNE No parity bit is used
oFF Parity bit is fixed as a zero
dAtA 8bIt 8 bit data format
7bIt 7 bit data format
StoP 1bIt 1 stop bit
2bIt 2 stop bits gives a “force 1” parity bit
AddR ____ Address for 485, placeholder for 232
SFty PwoN dSbL Turn on: in oPER Mode, ENTER to run
ENbL Turn on: program runs automatically
RUN.M
dSbL ENTER in Stby, PAUS, StoP runs
ENbL ENTER in modes above displays RUN
SP.LM SP.Lo ____ Low Setpoint limit
SP.HI ____ High Setpoint limit
LPbk dSbL Loop break timeout disabled
ENbL ____ Loop break timeout value (MM.SS)
o.CRk ENbl Open Input circuit detection enabled
dSbL Open Input circuit detection disabled
t.CAL NoNE Manual temperature calibration
1.PNt Set offset, default = 0
2.PNt R.Lo Set range low point, default = 0
R.HI Set range high point, default = 999.9
ICE.P ok? Reset 32°F/0°C reference value
SAVE ____ Download current settings to USB
LoAd ____ Upload settings from USB stick
VER.N 1.00.0 Displays firmware revision number
VER.U ok? ENTER downloads firmware update
F.dFt ok? ENTER resets to factory defaults
I.Pwd No No required password for INIt Mode
yES ____ Set password for INIt Mode
P.Pwd No No password for PRoG Mode
yES ____ Set password for PRoG Mode
Omega Engineering | www.omega.com