AWS-C Installation and operating manual
7
SET TARGET PRESSURE MODE
In this mode we can set target pressure in tyre by pr and – buttons. Target
pressure value is located in right upper part of display.
Picture 7: Set target pressure
The lowest target pressure value is 0,5 bar. Target pressure can be set in resolution
0,1 bar. The highest target pressure value is 9,5 bar. The highest target pressure
value can be limited to value 8bar, 6,5bar or 5bar. For limitation please contact
manufacturer.
After target pressure is set user can connect hose to the tyre and inflation will start
automatically unless pressure in the tyre is below 0,3 bar. In this case you need to
press button for manual start.
If additional safety is required manufacturer can change firmware so that confirmation
is required before inflation starts.
Picture 8: Confirm start of inflating
Attention
If user presses button for manual start of inflation before hose is connected to the
tyre air will start to blow out of the hose under high pressure. This can be dangerous.
