AWS-C Installation and operating manual
6
Start up
At start-up light and audible signal will appear for short time. On the display information
about firmware appear for short time.
Picture 5: Information display at start-up
Inflation procedure / pressure correction
Controller has three modes:
Sleep mode.
Set target pressure mode.
Inflation /pressure correction mode.
SLEEP MODE
When controller is not active (no button is pressed) for more than two minutes it goes
to »sleep mode«. In this mode logo appear and target pressure goes to default value
2 bar.
Picture 6: Logo
If we press any button device will go from »sleep mode« to »set target pressure
mode«. If we connect hose to the tyre during »sleep mode« inflation will not start
automatically.
