Olympia Millennium-E, Owner'S Manual

Page: 89 / 235

The Ultimate Ice Resurfacer 81
8 CLEANING AND MAINTENANCE
8.1 Cleaning and Maintenance Safety Instructions
To perform the maintenance program, park the OLYMPIA with the conditioner in the fully
UP position and shift the gear lever to the neutral position (N).
Fully raise the snow dump tank and install the safety support bars.
Turn off the ice resurfacer.
Before starting any maintenance jobs, remove the ignition key from the lock and keep it
on your person. Put up a notice at the dashboard that says: DO NOT SWITCH ON! WORK IN
PROGRESS IN THE DANGER ZONE!
Dismount using the three-point procedure.
When working on any of the other hydraulically operated components of the OLYMPIA, also
secure them with safety bolts or props, so that a hazardous situation does not arise in the
event of a component failure. Whenever working on the conditioner it is recommended
that blocks be placed under it to prevent any possible injuries.
Maintenance and repair work must only be done by duly trained personnel. Specialists are
needed for some jobs (e.g. electricians, hydraulics technicians, etc.).
Before doing such jobs, the whole ice resurfacer must be switched off. To do this, push down
the Emergency shut off switch and disconnect the batteries from the resurfacer as shown in
section 6.1. Put up a warning notice there that says: DO NOT PLUG IN BATTERY CONNECTOR!
WORK IN PROGRESS IN THE DANGER ZONE!
Before starting the work, the OLYMPIA must also be secured with wheel chocks to prevent
it from rolling away. The red/white plastic chains must be clearly visible at the sides of
the machine. It is imperative that the wheel chocks are removed again before putting the
OLYMPIA back into operation (the red/white plastic chains serve as a reminder).