![background image](http://html1.mh-extra.com/html/olt/9x6-cabana-bevel/9x6-cabana-bevel_assembly-manual_3831876009.webp)
Important -
Make sure all walls are aligned
in their upright position. If not, water may
leak into your shed. Unsure if panel is
facing up or down? Compare solid wall
siding to window wall siding and match
orientation.
1st Rear Wall Panel
1st Rear
Wall Panel
side of shed
Front
Side
2x3 wall frame
Wall Plate
Flush with
Floor Framing
1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 9
1/2” overhang
Important:
Pilot hole ALL 2x3 Wall
Studs with 1/8” drill bit prior
to screwing. This will make it
much easier to attach
together.
Pilot Hole
first.
9.
Starting with
Solid Wall Panels
, carefully lay panel
face down. Position and attach a
Bottom Wall Plate
to
bottom of wall studs of each wall panel with
3 - 2 1/2”
Screws
. Position so plates are flush with framing.
Parts
Solid Wall Panels
(35” x 75”)
x 7
Bottom Wall Plates
(1 1/2” x 2 1/2” x 35”)
x 7
Hardware
S1
- 2 1/2” Screws
x 21 total
11.
The Front and Rear Wall Panels will sandwich the
Side Panels.
Note:
2x3 wall frame will sit flush with
floor frame, siding will overhang the floor horizontally
by approximately 1/2”.
10.
Starting at Rear Corner, position a Solid
Wall Panel on top of plywood floor. Depending on
your preference, you may use a solid or window
wall panel in this position. If using a solid wall,
make sure panel is facing up.