Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 35
Bottom Skirting
Bottom Door
3/8” gap at bottom.
Evenly spaced on sides.
V
ertical Door
T
rim
2” Black
Screws
73.
Place Bottom Dutch Door panel into
position. Gap 3/8” on bottom, evenly space
on sides, and attach hinge to doorway seam
trim with
2” Black Headed Screws.
Use
shim to help keep the door evenly spaced on
bottom. One of the extra roof shingles (see
parts list) can be used.
Slight gap.Top Trim overlaps
bottom trim to prevent water
from getting in.
1/4” gap on
inside.
74.
Place the Top Dutch Door Panel into place and gap top and bottom trims on the outside about 1/8”
apart. On the inside, horizontal door frames should be about 1/4” apart. Use a shim once again to help
you. Attach hinges to trim with
2” Black Headed Screws
provided.
2” Screws
3/4” Screw
Important:
Drill pilot holes with 1/8” drill bit prior
to securing with screws to prevent wood splitting.
On 3/4” screw, drill shallow pilot hole only.
2” Screws
75.
Attach
Door Handle
and
Exterior Black Barrel Bolt
to door.
Handle is positioned on top door, Barrel Bolt on bottom door. Attach Black
Barrel Bolt as illustrated above with
2”
&
3/4” Black Screws
. Note how
female part of Barrel Bolt is positioned higher than male. Do a dry run first
to position Barrel Bolt correctly. Attach Handle with 2” Screws, ensure
screws connect with inner door stud.
Hardware
Y3 - Door Handle
x 1 total
Y4 - Barrel Bolt
x 1 total
SB1
- 3/4” Black Screws
x 1 total
SB2
- 2” Black Screws
x 9 total
