Olivetti IC-420, Service Manual, Page: 27 / 61

25 Service Guide: Fiery® ES IC-420
Replacing Parts
7
If you are replacing the HDD with a new HDD, remove the HDD from its bracket.
Remove the four screws that secure the HDD to the HDD bracket (see Figure 11 ).
Do not touch the HDDs with magnetic objects (such as magnetic screwdrivers), and avoid placing magnetic-sensitive
items, such as credit cards and employee ID cards, near the HDDs.
Set aside the HDD bracket. You need to use the HDD bracket when you install the replacement HDD.
Figure 11:
Removing the HDD bracket
8
Place the HDD in an antistatic bag.
Replacement HDDs are shipped without any pre-installed system software. After installing a HDD, you must install the
appropriate system software.
To replace the HDD
1
If you are installing a new HDD, unpack the drive. If you are not installing a new HDD, skip to step 6 .
Do not drop, shake, or bump the HDD. Do not touch the HDD with magnetic objects or place magnetic-sensitive items
near the HDD.
2
Place the HDD inside the HDD bracket, and align the four holes on the HDD with the holes in the bracket.
Position the HDD inside the HDD bracket as shown in Figure 11 on page 25.
3
Replace the four screws that attach the bracket to the HDD.
Make sure that you use the same screws that you removed earlier.
4
Connect the SATA data cable to the SATA data connector on the HDD.
Important:
Make sure to support the HDD as you remove the screws. Do not loosen or remove the screws on the
HDD covers. Loosening or removing these screws will break the seal and void the HDD warranty.
1 Screw (1 of 4)
2 HDD bracket
3 HDD
3
2
1
Y119660-9 Service Guide