Olivetti IC-420, Service Manual, Page: 24 / 61

22 Service Guide: Fiery® ES IC-420
Replacing Parts
DIMM
DIMM (dual in-line memory module) is held in place by levers at both end of the DIMM socket.
The standard memory configuration consists of two 2GB DIMM installed in DIMM sockets on the motherboard.
Note:
Approved DIMMs are available from your authorized service/support center.
To replace a DIMM
1
Access and open the Fiery ES, as described on page 18 .
2
To release a DIMM, push outward on the levers on each side of the DIMM (see Figure 9 ).
Figure 9:
Releasing a DIMM
3
Remove the DIMM by pulling it toward the chassis fan.
4
To replace a DIMM, position the DIMM in the socket and press the DIMM straight down toward the motherboard, so
that the levers lock the DIMM into place (see
Figure 9 on page 22).
Note:
DIMM fits in the socket only one way.
Make sure that the levers close securely around the ends of the DIMM and that the DIMM is fully seated in its socket.
1 Levers
2 DIMM
1
1
2
Service Guide Y119660-9