Oliver 6320, Owner'S Manual, Page: 32 / 56

32 | Page Oliver Machinery 6320 Sander
Belt Tracking Adjustment
Run the sander for 20-30 seconds to observe the
tracking of the sanding belt. The sanding belt
should track within the platen. If the sanding belt
is not tracking properly,
TURN OFF THE SANDER
IMMEDIATELY.
If adjustment is needed:
1. Turn off the sander.
2. Rotate the belt tracking control knob. Turn
the knob clockwise to shift the belt up and
vice versa.
3. Adjust belt tracking by rotating the bolt 1/10
turn at a time. Turn on the machine and run
the sander for 20-30 seconds to verify the
adjustment.
4. Repeat steps 1-3 as needed.