Oliver 6320, Owner'S Manual, Page: 18 / 56

18 | Page Oliver Machinery 6320 Sander
Sanding Belt Installation
1. Remove the eye bolts for lifting the sander
and open the belt tension lever access door.
2. Pull up the belt tension lever to install a
sanding belt.
3. The sanding belt runs in a counter-clockwise
direction. Make sure the arrows on the back
of the sanding belt align with the belt
running direction.
4. Loosen the lock knob under the belt guard to
open the guard.
5. Slip the belt evenly and gradually into both
drums until the belt is sitting in the middle of
the drums.
6. Tighten the sanding belt by moving the belt
tensioning lever back to its original position.
When the sanding belt is properly tensioned,
it should not slip off from the drums.
7. Close the belt guard and lock the guard with
the lock knob.
8. Close the belt tension lever access door.
Instead of reinstalling the eye bolts, install
the pair of knobs provided to lock the door.
Keep the eye bolts so the sander can be
safely moved in the future.