Oliver 6320, Owner'S Manual, Page: 25 / 56

6320 Sander OLIVERMACHINERY.NET 25 | Page
Table Height Adjustment
To set the height of the main table:
1. The main table can be raised and lowered
with the table height handwheel. Unlock the
handwheel before setting the table height.
Make sure the table is positioned at least
1/16
” above the bottom edge of the sanding
belt.
2. TIP : Occasionally adjust the table height and
make use of various sections of the sanding
belt. This helps to even out the wearing of
the sanding belt and extend its life.
3. If the sanding belt is in a tilted position,
raising the table will create a bigger gap
between the belt and the table. To minimize
the gap, unlock the horizontal travel
handwheel and move the table towards the
sandbelt. Make sure the table does not touch
the belt, as this will damage the table.
4. Lock all handwheels after the adjustment.
To set the height of the side table:
1. Loosen the lock knob on the table bracket.
2. Adjust the table height. Make sure the table
does not touch the abrasive surface and is
positioned at least 1/16
” above the bottom
edge of the sanding belt.
3. Tighten the lock knob to secure the side
table.
WARNING
Position the table at least 1/16 ” above the
bottom edge of the sanding belt. Doing so
prevents materials or body parts from
getting caught between the table and the
belt, which can cause serious injury.
IMPORTANT
Move the table away from the sanding
belt before lowering the table or moving
the belt back to the upright position.
Failure to do so can damage the machine.