Oliver 6320, Owner'S Manual, Page: 21 / 56

6320 Sander OLIVERMACHINERY.NET 21 | Page
Test Run
This sander has been tested and calibrated before leaving the manufacturing facility. It should not require
extensive adjustments. The essential checks provide an opportunity to get familiarized with the sander,
and it helps to discover any potential issues before conducting production work.
Mechanical Parts Inspection
1. Make sure the sander is disconnected from
the power source.
2. Make sure the belt tension lever access door
and the sanding belt guard is closed and
locked by the lock knobs.
3. Make sure the sanding belt is tensioned and
it is not catching the guard, miter gauge, and
table.
4. Set the miter gauge to 0° so the fence of the
miter gauge is perpendicular to the sanding
belt, then check the setting with a square.
5. The sander is shipped with the sanding belt
in the upright position. Use the belt tilt
handwheel to tilt the belt all the way to the
back. The belt should stop at a tilt angle of
45 degrees.
6. Use the table height handwheel to raise the
table to its highest position.
7. Use the table horizontal travel handwheel to
move the table towards the sanding belt.
The table should shift towards the sanding
belt and form a small gap with the belt.
8. Reverse steps 6 and 7 to move the table to
its original position.
9. Change the sanding belt back to the upright
position. Make sure the belt is perpendicular
to the table.