Oliver 6320, Owner'S Manual, Page: 17 / 56

6320 Sander OLIVERMACHINERY.NET 17 | Page
Lifting the Sander from the Pallet
The sander is mounted on the pallet to stabilize
the machine during transport. Remove the two
retaining brackets from each side of the sander
before lifting the sander from the pallet.
Connect the lifting slings to the lifting eye bolts
and ensure the slings are balanced, then lift the
sander from overhead and move to the
designated location for operation.
Lower the sander gently to the floor to prevent
damaging the leveling feet and the cabinet.
Cleaning
To prevent rusting during shipment, the
unpainted cast iron main table and end table are
covered with rust protectant and plastic film.
A part of the plastic film is held in between the
main table and the miter gauge. Remove two
socket cap screws to unmount the miter gauge
temporarily to release the plastic film and clean
the entire table.
Wipe off the rust protectant with paper towels.
Using WD-40 can help to dissolve the rust
protectant and make it easier to remove.
Once all rust protectant is removed, routinely
coat the tabletops with rust preventive such as
Boeshield® T-9 or paste wax. Do not use rust
preventives that contain silicone, which is known
to interfere with certain finishes and glues.
After the tables are cleaned, wipe off the excess
oil at the bottom of the miter gauge and re-
mount the miter gauge.