OLiPower BRE-I-5K, User Manual

Page: 19 / 62

19
·
If the unit is not balanced apply ballast, any protruding parts should not be
supported by hand.
·
The inverter should be installed so that the operating panel shall be easily
accessible- easy access to the electrical power connection point.
·
Accessible for maintenance and repair work.
·
Parts serving for support or immobilization of unit shall be designed and
manufactured to minimize the risk of physical injuries and accidental loosening of
fixings.
·
Loading capacity and hardness of the supporting surface, load rating of mounting
bracket should be at least four times the weight of the devices according to
lEC62109-1. And supporting characteristics will be impaired by wear, corrosion,
material fatigue or ageing, this should be calculated by inspection of the design
data of supporting material and consulting construction engineer.
5.6 Installation steps
Step 1: Screw the wall bracket on the wall
·
Use the hole positioning plate to confirm the position of the hole. Use a bubble
or digital level to adjust the position of the mounting holes and mark the position
with a marker.
Figure 5-2
·
Drill holes with d 10 driller carefully, make sure the holes are deep enough (at
least 45mm) for install and tight the expansion tubes.
·
Install the expansion tubes in the holes, and tight them. Install the wall bracket
using the expansion screws in the screw package.
Step 2
:
Hang the Inverter on the wall bracket
·
Transportation of the inverter needs at least 2 people; each one needs to use
the handles at the sides of the inverter.