Olimpia splendid Unico Boiler, Instructions For Installation, Use And Maintenance Manual

Page: 50 / 124

50
ENGLISH
- electronic and fluorescent lighting may interfere with communications between the remote control and the air conditioner,
- remove the batteries in case of prolonged disuse of the remote control.
3.2.2 Fitting the batteries
The remote control exclusively requires 2 dry LR03 1.5 V batteries (not included with the supply).
Used batteries should be disposed of solely by depositing them into the appropriate collection points arranged by the Local Authorities
specifically for this type of waste.
Replace both batteries at the same time.
To insert the batteries remove the spring-latch cover on the back of the remote control.
The batteries have to be inserted according to the positive and negative pole markings in the bottom of the battery compartment.
Close the spring-latch cover after inserting the batteries.
3.3 UNICO BOILER MASTER
The remote control is the interface between the user and the air conditioner. It is therefore particularly important to familiarize
yourself with the parts of the remote control that relate to this interface.
All the references indicated in the following paragraphs refer to figure 44 (unless otherwise specified).
3.3.1 Description of the remote control (fig. 44)
Buttons : used to set or bring up machine functions.
T1 ON/OFF (standby).
T2 Well-being key (automatic)
T3 Night well-being mode.
T4 Operating mode selector.
T5 Fan speed selector.
T6
Button for setting timer and programs.
T7 Button for increasing (+) or decreasing (-) the temperature/time settings.
T8 Button for activating the FREE COOLING air change system (not available in this model).
T9 Movable baffle adjustment On/Off button.
T10 Reset button.
T11
Program start button.
Display : shows the operating state and the values of the settings being carried out.
D1 Fan speed or automatic operating mode indicator (AUTO).
D2
Heating.
D3 Cooling.
D4 Dehumidifier only.
D5 Air change activation (not available in this model).
D6 Night operation switch.
D7
Automatic operation switch.
D8 First operating program switch.
D9 Second operating program switch.
D10 Temperature indicator (thermometer) or time indicator (H/M).
The remote control is also equipped with a sliding cover that can be positioned so as to permit access only to the ON/OFF, Automatic
operating and NIGHT MODE buttons.
3.3.2 General power-on and management of UNICO BOILER MASTER
To manage the appliance with the remote control, it will be necessary to have activated the main switch which is included on the
electrical power supply line (the technician that installed the appliance could offer more details regarding the position), or insert
the power plug of the appliance into the main power supply socket.
The UNICO BOILER MASTER machine is fitted with a power switch (fig. 42 ref. A) located below the lower safety guard (fig. 42
ref. B); to run it must be in “I” position.
Once these operations have been carried out, the machine may be regulated using the remote control.
To transmit commands to the unit, the front of the remote control must be pointed towards the unit’s console.
The device emits a beep when it receives a command.
The maximum distance for transmission of commands is about 8 meters.
3.3.3 Turning the unit ON/OFF
The unit is switched on or off using button T1 (fig. 44).
The system for controlling the appliance is equipped with a memory so all the settings will not be lost when the unit is switched off.
3