40496501TH Draft Version
92
Item No.
9
10
Items
Installing print head
Alignment of horizontal
printing
Standard Value
Illustration
Adjustment Method
1
In installing the print head, accurately
bump it to the inpinging plate on the
carriage frame.
Notes:
The print head should be installed/
removed at 1-range position.(prevent
protector deformation)
2
How to tighten screws in installing
the print head.
a.Lightly tighten the right and left screw
while pushing the print head against
the carriage.
b.In tightening the screws first, (note)
make sure to tighten the left screw af-
ter tightening the right screw while
pushing the head against the carriage.
Notes 1:
To prevent the float of head when tight-
ening the screws.
Notes 2:
Tightening the screws while pressing
the head in the direction of " ".
3
Adjust the backlash of screws so
that the print head can meet the
center of the protector.
1
Set a continuous paper (1P, 15 inch
width, 55kg sheet) onto the printable
position.
2
Press
5
switch to go to the menu
mode. Press
2
to display "Set-Up".
Next, press
3
to display
"Registration1". (The printer starts
Registration1 printing.)
Open the access cover to confirm that
the printing is in progress and close it,
and then execute the correction after
pressing the ON-LINE switch.
Print head
Carriage frame
Impinging plate
Print head
Left screw
Right screw
Mounting screw
Print head
Install the print head so that the
center of the print head meet that
of protector.
Protector frame
Summary of Contents for PACEMARK 4410
