Oki ML1120, Technical Reference Manual

Page: 81 / 254

Technical Reference Guide – Operator interface > 81
F
UNCTION
> Prints in 10 CPI Utility mode.
> Both parallel and USB interfaces are available.
> Paper auto Skip Over Perforation (SOP) by menu default
value continuous for both. If SOP is enabled, one inch
from the bottom of the paper will not be printed.
> Printing starts when more than 16 bytes of data are
received (line full).
C
ONTINUOUS PAPER AUTO
-
LOADING
Load continuous paper on the tractor (at a position such that the
paper does not cross the paper-end sensor).
In this situation, pressing the LOAD/EJECT switch starts auto-
loading.
When the paper does not cross the paper-end sensor within an
8-in feed of the paper, a paper-end state occurs.
The print position of the first data line can be set by menu
function or in first character setting mode.
NOTE
C
ONTINUOUS PAPER AUTO
-
PARKING
With continuous paper loaded in continuous paper mode,
pressing the PARK switch starts auto-parking.
When the end of continuous paper is detected by the time the
paper is fed 22 in reverse, auto-parking finishes and a paper-end
state is established.
If the end of continuous paper is not detected after a 22-in
reverse feed, auto-parking terminates. The position that is set
when the auto-parking terminated becomes TOF.
Pressing the PARK switch again repeats the auto-parking
operation.
TOF is the position that is set when the operation was
completed properly.