Oki MB472w, Maintenance Manual

Page: 94 / 224

Oki Data CONFIDENTIAL
45762101TH Rev.1
3-4
3. MAINTENANCE MENUS
Item1 Item2 Item3 Item4 Item5 Value
Default
value
ODA
Default
value
OEL
Default
value
JP
Notes
Password Panel
Maintenance Sound Test Low
Middle
High Select the volume of the forced buzzer.
For the buzzer pattern, use the error sound (three buzzes)
Copy
Maintenance Print Check
Pattern Execute Starts printing from the panel using a copy evaluation test chart inside the FW.
Scanner
Maintenance Scanner
Calibration Execute Starts execution of scanner calibration. Instead of being conducted automatically
after operating for a certain period of time, calibration is executed by the user as
needed. During calibration, the fact that calibration is underway is displayed.
Note: Also included under AdminSetting.
Adjust Scan
Position FBS Side Reg. +8 ~ -8 mm 0 0 0 Adjusting the position of the scanning start pixel by one Step=4/600 dpi (= 0.17mm) at
the book scanning.
Front Edge +30 ~ -30 mm 0 0 0 During book scanning, add a value for the basic value (= 5 mm) when reading the
shadow of the front edge of the document.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
ADF
(Front-
side) Side Reg. +8 ~ -8 mm 0 0 0 Adjusting the position of the scanning start pixel by one Step=4/600 dpi (= 0.17mm) at
the book scanning.
Front Edge +30 ~ -40 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
Back Edge +30 ~ -40 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when
skipping the back edge of the document. To read the shadow of the back edge of the
document, add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
ADF
(Back-
side) Front Edge +30 ~ -40 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
Back Edge +30 ~ -40 mm 0 0 0 When reading a document from the ADF, add a value for the basic value when
skipping the back edge of the document. To read the shadow of the back edge of the
document, add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
Adjust
ADF Scan
Position +30 ~ -30 mm 0 0 0 Set the CIS reading position of the ADF for the focusing standard.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm). This is correlated to
adjustment of the ADF front edge position.