Oki Dr.63514, User Manual, Page: 71 / 101

Chapter 3. Setting Up and Starting Up
3-3
n
Note 1
n
_____________________________________________________________________________________________________
Set the emulator switches to the settings in the following table.
Switch label Setting
MODE EMU
VDD.VDDI.SEL IN
OSC.SEL IN
XT.SEL IN
48/64 option
CMP OFF
BACKUP ON
_____________________________________________________________________________________________________________________
n
Note 2
n
_____________________________________________________________________________________________________
The IBM PC/AT and compatibles do not support the 51,200bps and 76,800bps speeds.
When turning on or resetting the Dr.63514, if an initialization message is not produced on
the dedicated debugger’s screen or a communication error occurs, lower both the Dr.63514
baud rate setting and the dedicated debugger’s speed parameter.
_____________________________________________________________________________________________________________________
1.2 Switch and Jumper Settings
This section describes the switch and jumper settings needed before starting the emulator.
(1) MODE switch
Set the MODE switch to the desired mode.
Operating mode MODE Switch
Emulation Mode EMU
Evaluation Mode EVA
(2) BAUD switch
Set the BAUD switch to the Host computer baud rate. However, note that this setting is not required if
the emulator is operated in evaluation mode.