Chapter 3. Setting Up and Starting Up
3-2
1. Setting up and turning on the Dr.63514 in-circuit emulator
This section describes the set up procedure that must be followed prior to turning on the Dr.63514 in-
circuit emulator, and then the procedure for turning on the emulator.
1.1 Device configuration
Before using the emulator for debugging, use the dedicated emulator setup utility to configure it for the
target microcontroller. This utility runs on the development host, transferring device information to the
emulator over a serial cable. The BAUD switches at the rear of the emulator specify the transfer speed.
The emulator stores this configuration data in a built-in EEPROM, so reconfiguration is only necessary
when the target microcontroller changes.
Before using the utility, set the SETICE switch at the rear of the emulator to its ON position, the one for
updating this EEPROM.
SETICE switch
Operating mode
ON
Device configuration
OFF
Debugging (evaluation or emulation)
The ICE setup utility runs on the host computer, transferring device information to the Dr.63514 In-
Circuit Emulator through the RS232C interface. The communication baud rate of the RS232C interface
is set by the dipswitches (BAUD) on the rear panel of the Dr.63514 In-Circuit Emulator unit.
BAUD
switch
baud rate
38400
19200
9600
4800
4,800bps
OFF
OFF
OFF
ON
9,600bps
OFF
OFF
ON
OFF
19,200bps
OFF
ON
OFF
OFF
38,400bps
ON
OFF
OFF
OFF
51,200bps
ON
ON
ON
OFF
57,600bps
ON
ON
OFF
ON
76,800bps
ON
OFF
ON
ON
115,200bps
OFF
ON
ON
ON
The emulator is now ready for the update.
Summary of Contents for Dr.63514
