© 2015 OJ Electronics A/S
(Home screen functions)
49
W
at
erline
r
oom
s
ensor with Display -
type W
lD
t
3
Everyday use:
automatic mode:
In automatic mode, a clock symbol (
) is shown along with the actual temperature.
The temperature is controlled by the master's comfort setpoint or by a room controller (WLCT) if this WLDT
is included in the WLCT's area (zone).
Use the UP (
△
) or DOWN (
▽
) button to adjust the relative setpoint ±4°C compared to the generic setpoint.
The display will show how much the set point has been offset relative to the generic set point:
Example:
The display will flash for 5 seconds and will then revert to showing the actual temperature.
Comfort mode:
Fixed comfort mode - Press the OK (√) button once to activate.
In comfort mode, a sun symbol (
)is shown along with the actual temperature.
The temperature is now controlled only by the master's comfort setpoint (factory setting 21°C), overriding
any programmed 4-event schedules in the system.
Use the UP (
△
) or DOWN (
▽
) button to adjust the relative setpoint, like in automatic mode.
setback mode:
Fixed setback mode - Press the OK (√) button once to activate.
In setback mode, a moon symbol (
) is shown along with the actual temperature.
The temperature is now controlled only by the master's setback setpoint (factory setting 18°C), overriding
any programmed 4-event schedules in the system.
Use the UP
(△
) or DOWN (
▽
) button to adjust the relative setpoint, like in automatic mode.
oFF mode:
OFF mode - Press the OK (√) button once to activate.
In setback mode OFF is shown.
The temperature is now controlled only by the master's frost protection setpoint (factory setting 5°C),
overriding any programmed 4-event schedules in the system.
The system is now off, but still with frost protection enabled.
Summary of Contents for WLM3
Page 55: ... 2015 OJ Electronics A S 55 ...
