© 2015 OJ Electronics A/S
37
Display
Activating the room controller (first-time startup)
W
at
erline
r
oom Contr
oller -
type W
lC
t
3
J
G
H
K
I
1. The first time power is connected (or after a factory reset), the clock and weekday will flash and must
be set.
2. The channel to be controlled from this room controller must then be selected.
3. Finally the “Area” (other channels) controlled from this WLCT3 must be selected.
NOTE: If you need to adjust the time at a later date, insert a pin into the hole marked for setting the clock.
AREA SETUP - see next page.
Press the UP (
△
) or DOWN (
▽
) button to select the correct
hours
and then press the OK (√) button.
Press the UP (
△
) or DOWN (
▽
) button to select the correct
minutes
and the press the OK (√) button.
Then press the UP (
△
) or DOWN (
▽
) button to select the correct
day
and press the OK (√) button to confirm.
1-7
G:
H:
I:
Automatic mode
Manual mode
Time and
temperature
J:
K:
Day number
4-event symbol
Wake Out
Night Home
Buttons
Summary of Contents for WLM3
Page 55: ... 2015 OJ Electronics A S 55 ...
