- 9 -
5 - 3. Height Adjustment of Passing and Holding Plates (How to Remove the Rail)
● If screws stop before reaching the stopper, adjust both the passing and holding plates.
Note:
Be sure to eject all screws from the before replacing the rail.
● Loosen the bit guide height adjustment screws. (See Picture 5)
● Slightly loosen the front and rear rail fixing screws. (See Picture 6)
● Lift the bit guide “Assembly” and pull the rail out in a horizontal direction. (See Picture 7)
Bit guide height
adjustment screws
Picture 5
Rail
Bit guide “Assembly”
Picture 7
(Front) rail
fixing screw
(Right under）
(Rear) rail
fixing screw
Picture 6
