- 17 -
Adjust the number of screws to ensure the proper alignment and smooth flow of screws. (See Picture 2)
● Adjust the scooping chamber to its lowest position by turning the power to the machine on and off.
● Fill the scooping chamber with screws up to 2mm below the rail groove.
● Be sure not to cover the front of the sliding plate with screws.
● Always ensure there are adequate screws for the operation.
6 - 1. Number of Screws
6. Basic Operation
The driving motor repeats normal rotation and an inversion for about 2 seconds at a time, and the scooper carries screws
to the rail. The vibrator (solenoid) continuously sends screws to the front stopper to be picked up using the screwdriver.
Note:
If no screws are sent for approximately 10 seconds, vibration of a rail becomes stlonger. (The vibration sound, also, in-
creases; however, this is not a problem.)
If no screw is not detected for about 20 more seconds, then the machine stops operating. When you want to start opera-
tion again, turn the power switch OFF and ON again or a stopper is operated (extraction sensor perception),
View from the Above
Do not cover the front of the sliding plate with screws.
Picture 2
