－
24
－
⑤
⑥
⑦
⑧
⑤
Using the accompanying hex wrench, loosen the 2 hex
head bolts from the driving pulley and remove it.
If the bolts are hard to access, rotate the motor pulley
with the hex wrench.
⑥
Remove the motor attaching screws.
⑦
Pull the escaper assembly forward and pull the motor
out from the right side of the machine.
Next, remove the motor harness from the clip and remove
the connector from the board.
For reassembly, reverse the disassembling procedure.
⑧
When attaching the driving pulley, one holding screw
should be put in the straight side of the D cut of the
motor shaft.
[CAUTION]
Do not use excessive force with the motor wiring
in order to avoid wire breakage.
The part number of the main motor is
TPO01002 #17
D-cut
Holding screw
Loosen the 2 fixing bolts and
remove the driving pulley.
Remove the motor
attaching screws.
Remove the motor.
Fix the holding screw
on the D cut of the
motor shaft.
